Header and Footer [message #157438] |
Thu, 02 February 2006 07:57 |
karthi
Messages: 42 Registered: December 2000 Location: B'lore
|
Member |
|
|
Hi all,
I'm using Oracle Reports for years.
I never used the Header Section and Trailer Section(footer) and I want to know, whts the use of it and where to use?
I designed a simple report only with header and trailer and no body, but the trailer part is printing in the second page.
For eg.
We have designed a report wiht header and footer, and while printing it has to print in the same page for all sizes of papers.
What I mean is, I've to design a report with header and footer in such way that it has to print in the top and bottom for A4size, A5size paper, etc...
I hope everyone can understand my problem. Thank you.
bye
karthik
|
|
|
Re: Header and Footer [message #157848 is a reply to message #157438] |
Mon, 06 February 2006 12:46 |
RJ.Zijlstra
Messages: 104 Registered: December 2005 Location: Netherlands - IJmuiden
|
Senior Member |
|
|
karthik,
I don't get it:
As far as I understand your message, you want to make a report (or a template??) that will somehow 'magically' transform itself to print on any paper-size?
Please elaborate.
Regards,
Rob Zijlstra
|
|
|
|
Re: Header and Footer [message #158793 is a reply to message #157438] |
Tue, 14 February 2006 07:45 |
vban2000
Messages: 207 Registered: March 2005
|
Senior Member |
|
|
Hi karthik
Header and Footer
Reports 9i (same for 6i, I think...)
View -> Margin (to see the margin)
Press <CTRL> + <-> (to zoom out)
everything outside the black box is margin, you can put on top (as header), below as footer. you might need to play with the size of the black box. so as to give enough space for your header and footer..
Paper Size
Check your report, have Unit of Measurement as Inch (you can see this by viewing the Property Inspector of Report)
Go to Paper Layout - Main Section on your Object Navigator.. Chnage the Width and Height accordingly. I use (8.5 as width, 11 as height). Report Width of 80, Report Hight of 66.
Play around with the setting, you should be able to configure it.
HTH
Regards
AnDy
|
|
|